Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
- Engine
   2.1. Technical characteristics
   2.2. Greasing system
   2.3. Maintenance and engine repair
   2.4. Compression check
   2.5. Dismantle and engine installation assembled
   2.6. Engine support
   2.7. Inlet collector and laying
   2.8. Final collector and laying
   2.9. Cover of the case of a cam-shaft
   2.10. Pulley of a cranked shaft
   2.11. Forward cover of a gear belt
   2.12. Camshaft cogwheel
   2.13. Cogwheel of a cranked shaft
   2.14. Back cover of a gear belt
   2.15. Adjustment of a tension of a gear belt
   2.16. Verification of the angular provision of a camshaft
   2.17. Forward consolidation of a cranked shaft
   2.18. Camshaft. Levers. Hydrojacks of gaps
   2.19. Klapannye of a spring. Consolidations of cores of valves
   2.20. Head of cylinders. Camshaft case
   2.21. Repair of a head of the block of cylinders
   2.22. Dismantle of valves
   2.23. Directing plugs of valves
   2.24. Expansion of openings of plugs
   2.25. Valves
   2.26. Klapannye of a spring
   2.27. Saddles of valves
   2.28. Consolidations of valves
   2.29. Height of a core of the valve concerning a head of the block of cylinders
   + 2.30. Pushers of valves with hydrojacks of gaps
   2.31. Oil pallet
   2.32. A reception branch pipe with the oil filter
   2.33. Oil pump
   2.34. Repair of the oil pump
   2.35. Pistons and rods
   2.36. Flywheel. Back consolidation of a cranked shaft
   2.37. Cranked shaft
   2.38. Rods and radical bearings
   2.39. Replacement of loose leaves
   2.40. Piston group and rods
   2.41. Piston fingers and rings
   2.42. Block of cylinders
   2.43. Installation of pistons
   2.44. Disk balancing with a gear wreath
   2.45. Repair of carving openings
   + 2.46. Diagnostics of malfunctions of the engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

2.5. Dismantle and engine installation assembled

To remove or disconnect

PERFORMANCE ORDER

1. Relay of the fuel pump.

2. To start the Engine and let's to it work to a stop.

3. To scroll a cranked shaft within 10 seconds.

4. Negative wire of the storage battery and "mass" wire of the engine.

5. To merge cooling liquid (to remove the bottom hose of a radiator).

6. Air purifier branch pipe.

7. Top hose of a radiator.

8. Heater hose.

9. A cable from the butterfly valve case.

10. Vacuum hoses:
      – brake amplifier;
      – vacuum sensor;
      – from the inlet pipeline to an isparitelny tank;
      – from the butterfly valve case to an isparitelny tank.

11. A cable from the butterfly valve case to transmission (only automatic transmission).

12. Fuel pipelines from the butterfly valve case.

13. Sockets of electric wires:
      – ignition distributor;
      – plait of wires of the control panel;
      – sensor of concentration of oxygen;
      – sensor of pressure of oil;
      – the sensor of temperature of cooling liquid;
      – speedometer sensor;
      – fuel nozzles of system of injection of fuel;
      – sensor of provision of a butterfly valve;
      – idling valve;
      – "mass" wires of the case of a cam-shaft and inlet collector;
      – to remove electroconducting collars.

14. The ignition coil with wires.

15. Mnogoshtyreva I will corrode control panel electroconductings.

16. Socket of the switch of a lamp of a backing.

17. Socket of the valve of blocking of the hydrotransformer (only automatic transmission).

18. Neutral/start switch.

19. To lift the car.

20. The final pipeline with converter.

21. A stopper from a case of transmission and to take out the driving roller.

22. A condenser cable for suppression of hindrances from a transmission case.

23. Coupling guard.

24. The bottom bolts of fastening of a case of coupling to the block of cylinders.

25. To lower the car.

26. To attach cables to engine loops.

27. To substitute support under transmission.

28. Forward right support of the engine.

29. Forward left support of the engine.

30. Back support of the engine.

31. The top bolts of fastening of a case of coupling to the block of cylinders.

32. To disconnect the Engine from a case of coupling and to lift the Engine.

To establish or attach

PERFORMANCE ORDER

1. To lower the Engine and to connect to a coupling case.

2. The top bolts of fastening of a case of coupling to the block of cylinders.

3. Forward right support of the engine.

4. Forward left support of the engine.

5. Back support of the engine.

6. To clean support from under transmission.

7. To unhook cables from loops.

8. To lift the car.

9. Coupling guard.

10. The bottom bolts of fastening of a case of coupling to the block of cylinders.

11. Driving roller of coupling.

12. A condenser cable for suppression of hindrances to a transmission case.

13. The final pipeline with converter.

14. Bottom hose of a radiator.

15. To lower the car.

16. Neutral/start switch.

17. Socket of the valve of blocking of the hydrotransformer (only automatic transmission).

18. Socket of the switch of a lamp of a backing.

19. Mnogoshtyreva I will corrode control panel electroconductings.

20. The ignition coil with wires.

21. Sockets of electric wires:
      – ignition distributor;
      – plait of wires of the control panel;
      – sensor of concentration of oxygen;
      – sensor of pressure of oil;
      – the sensor of temperature of cooling liquid;
      – speedometer sensor;
      – fuel nozzles of system of injection of fuel;
      – sensor of provision of a butterfly valve;
      – idling valve;
      – "mass" wires of the case of a cam-shaft and inlet collector.

22. To establish electroconducting collars.

23. Fuel pipelines to the butterfly valve case.

24. A cable from the butterfly valve case to transmission (only automatic transmission).

25. Vacuum hoses:
      – brake amplifier;
      – vacuum sensor;
      – from the inlet pipeline to an isparitelny tank;
      – from the butterfly valve case to an isparitelny tank.

26. Heater hose.

27. Top hose of a radiator.

28. Air purifier branch pipe.

29. To fill in cooling liquid.

30. Negative wire of the storage battery and "mass" wire of the engine.