| 1. To remove driving belts, the conditioner compressor, the pump of the steering amplifier, the generator. |
| 2. Pipelines of the pump of the steering amplifier. |
| 3. To turn a cranked shaft for a head of a bolt of a cogwheel that the piston of the first cylinder was established in situation 10" to VMT. The label on a pulley of a cranked shaft should coincide with the index on a back cover of a gear belt (see fig. Installation of a cranked shaft on a label on a pulley). |
| 4. To remove bolts and a forward cover of a gear belt. |
| 5. To adjust a tension of a gear belt in the following sequence. |
| 5а. To remove three bolts of 151 fastenings of the water pump. |
5б. To expose the adjusting lever on the opening center in an arm, as is shown in fig. Adjustment of a natyazhitel of a belt. Slightly to tighten three bolts of fastening of the water pump.
Prevention
For fixing from rotation of an arm and the lever to insert into an opening a screw-driver.
|
| 5в. For the correct installation of details to turn a cranked shaft on two turns (to remove three bolts of fastening of the water pump). |
| 5г. To turn the case of the water pump counter-clockwise, holding the lever index on an arm label. |
| 5д. To tighten bolts of fastening of the water pump the moment of 20-30 Nanometers. |
