Daewoo Nexia

since 1994 of release

Repair and car operation


Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
- Steering
   12.2. General description
   12.3. Reechny steering mechanism assembled
   12.4. Tips of steering drafts
   12.5. Steering drafts
   12.6. Casing of a case of the steering mechanism
   12.7. Coupling of a steering shaft
   12.8. Sealing cover of an opening of a forward board of the Body
   12.9. Plunzher of a lath
   12.10. Shaft gear wheel
   12.11. Lath
   12.12. Needle bearing
   12.13. The directing plug of a lath
   12.14. Verification of the neutral provision of a lath
   12.15. Recommendations about replacement of consolidations in the hydraulic booster
   12.16. Check of level and having added working liquid
   12.17. Air removal from hydrosystem
   12.18. The steering mechanism with the hydraulic booster assembled
   12.19. Hoses and pipelines
   12.20. Tank
   12.21. Tips of steering drafts
   12.22. Steering drafts
   12.23. Plugs of hinges of steering drafts
   12.24. Coupling of a steering shaft
   12.25. Sealing cover
   12.26. Hydrocylinder pipelines
   12.27. Adjustment of a preliminary tightness of a spring of a plunzher
   12.28. Consolidations of a shaft of the hydrodistributor and top bearing
   12.29. Steering mechanism
   12.30. Verification of the neutral provision of a lath
   12.31. Belt of a drive of the pump
   12.32. Pulley of a drive of the pump
   12.33. Pump assembled
   12.34. Control levers on a steering column
   12.35. Steering wheel
   12.36. Ignition lock
   12.37. Steering column
   12.38. Lever switch, steering shaft, steering column (noncontrollable)
   12.39. Lever switch, steering shaft, steering column (adjustable)
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


8128da4b



12.27. Adjustment of a preliminary tightness of a spring of a plunzher
GENERAL INFORMATION

Lath support

AND. BEFORE ASSEMBLY TO GREASE WITH LITHIUM KONSISTENTNA GREASING

14. PLUNZHER
15. SEALING RING
16. LOCK-NUT
17. ADJUSTING STOPPER
18. SPRING
55. CASE

To adjust

Adjustment of a preliminary tightness of a spring of a plunzher of a lath

AND. 15-MM HEAD

16. LOCK-NUT
17. ADJUSTING STOPPER
55. CASE

PERFORMANCE ORDER
1. To weaken a lock-nut 16 and to wrap clockwise a stopper 17 against the stop in a case. Then to unscrew a stopper on 30–40 degrees.
2. Adjustment is made at the hung-out forward wheels in the neutral provision of a steering wheel. After adjustment it is necessary to check stabilization of operated wheels (self-return to neutral situation).
3. To wrap a lock-nut 16. Holding a stopper in motionless situation, to tighten a lock-nut the moment of 70 Nanometers.