Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
- Steering
12.2. General description
12.3. Reechny steering mechanism assembled
12.4. Tips of steering drafts
12.5. Steering drafts
12.6. Casing of a case of the steering mechanism
12.7. Coupling of a steering shaft
12.8. Sealing cover of an opening of a forward board of the Body
12.9. Plunzher of a lath
12.10. Shaft gear wheel
12.11. Lath
12.12. Needle bearing
12.13. The directing plug of a lath
12.14. Verification of the neutral provision of a lath
12.15. Recommendations about replacement of consolidations in the hydraulic booster
12.16. Check of level and having added working liquid
12.17. Air removal from hydrosystem
12.18. The steering mechanism with the hydraulic booster assembled
12.19. Hoses and pipelines
12.20. Tank
12.21. Tips of steering drafts
12.22. Steering drafts
12.23. Plugs of hinges of steering drafts
12.24. Coupling of a steering shaft
12.25. Sealing cover
12.26. Hydrocylinder pipelines
12.27. Adjustment of a preliminary tightness of a spring of a plunzher
12.28. Consolidations of a shaft of the hydrodistributor and top bearing
12.29. Steering mechanism
12.30. Verification of the neutral provision of a lath
12.31. Belt of a drive of the pump
12.32. Pulley of a drive of the pump
12.33. Pump assembled
12.34. Control levers on a steering column
12.35. Steering wheel
12.36. Ignition lock
12.37. Steering column
12.38. Lever switch, steering shaft, steering column (noncontrollable)
12.39. Lever switch, steering shaft, steering column (adjustable)
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment
|
Manzhetnye the consolidations applied to rotating shaft, show increased requirements to a condition of the condensed surface. Similar consolidations are established on a shaft gear wheel and a distributor shaft. At appearance of ducks in a zone of a steering shaft it is necessary to replace consolidations, previously having carefully examined and having cleared a condensed surface. The shaft is subject measurement only in the presence of deep defects of a condensed neck. If the neck of a shaft contacting to an edge of consolidation, is slightly injured by corrosion, it is necessary to clear and grind it by means of a thin skin. To replace a shaft follows only if this operation did not lead to elimination of leakages of working liquid. |
|
