Dismantle and installation of consolidation of a shaft gear wheel
A. TO PUT ON CONTACTING SURFACES VALA-SHESTERNI AND CONSOLIDATIONS THE GREASING CONTAINING CALCIC ANHYDRIDE CENTURY. CONSOLIDATION SHOULD SETTLE DOWN AFLUSH WITH THE CASE END FACE
4. CONSOLIDATION 5. SHAFT GEAR WHEEL
Initial and final provisions of a shaft gear wheel
AND. INITIAL SITUATION (7:30) CENTURY. FINAL SITUATION (9:00) PAGE. LYSKA'S MIDDLE FOR INITIAL SITUATION D. LYSKA'S MIDDLE FOR FINAL SITUATION
7. CASE
To remove or disconnect
Shaft gear wheel dismantle
5. VAL-SHESTERNYA 11. SPRING RING
Shaft gear wheel dismantle from a case
AND. TO KNOCK ON THE CASE FOR SIMPLIFICATION OF DISMANTLE VALA-SHESTERNI CENTURY. A VICE WITH OVERLAYS OF SPONGES FROM THE SOFT MATERIAL PAGE. HAMMER
5. VAL-SHESTERNYA 9. RUBBER PLUG
PERFORMANCE ORDER
1. To turn a shaft gear wheel 5 so that the directing level 10 was in the middle of a case window.
2. To note situation лыски in bulk gear wheel concerning a case.
3. Spring ring 11.
4. Shaft gear wheel 5.
To measure
PERFORMANCE ORDER
The directing level 10 should be in the middle of a case window.
To establish or attach Arrangement of a directing level in a case window
AND. IDENTICAL DISTANCES CENTURY. CASE WINDOW
10. THE DIRECTING LEVEL
PERFORMANCE ORDER
1. Shaft gear wheel. Situation лыски a shaft gear wheel should correspond put on a mechanism case to a label, the level 10 will be thus located in the middle of a case window.
