Prevention
It is forbidden to apply the brake liquids made on a mineral basis. It is not necessary to use also capacities which contained mineral oils, mineral brake liquids or water. Impurity of mineral oil or liquid will lead to swelling and failure of rubber consolidations. Hit of water will cause decrease in temperature of boiling of brake liquid and refusal of brake system at intensive braking. Capacities with brake liquid should be stored tightly closed and when opening to protect from dirt and water hit. Level of brake liquid in a tank of the main cylinder should be supported constantly in norm. It provides normal work of a hydraulic actuator and excludes air and moisture hit in system. However it is not necessary to overflow a tank as brake liquid should have expansion possibility when heating from heat being allocated in brake mechanisms and radiated by the engine.
The tank is located on the main brake cylinder: under a cowl at the left on a forward board of the Body. Before opening a tank cover, it should be wiped carefully from dirt. To open a cover and to finish level of brake liquid to norm, being guided by a label outside of a tank. It is recommended to apply brake liquid of the Delco Supreme N11 brand or equivalent to it. It is authorized to apply brake liquid only the DOT 3 type. |
