Daewoo Nexia
since 1994 of release
Repair and car operation
Deu Neksiya
+
Maintenance instruction
+
Maintenance
+
Engine
-
3. Engine (two top camshafts)
3.2. General description
3.3. Operation of hydraulic jacks of gaps
3.4. Greasing system
3.5. Maintenance and repair
3.6. Compression check
3.7. Dismantle and engine installation assembled
3.8. Maple belt
3.9. Engine support
3.10. Inlet collector and laying
3.11. Final collector and laying
3.12. Cover of the klapanny mechanism and laying
3.13. Pulley of a cranked shaft
3.14. Forward cover of a gear belt
3.15. Gear belt
3.16. Natyazhitel of a gear belt
3.17. Camshaft cogwheel
3.18. Cogwheel of a cranked shaft
3.19. Back cover of a gear belt
3.20. Forward consolidation of a cranked shaft
3.21. Camshaft. Hydrojacks of gaps of valves
3.22. Head of the block of cylinders
3.23. Repair of a head of the block of cylinders
3.24. Klapannye of a spring. Consolidations of cores of valves
3.25. Dismantle of valves
3.26. Directing plugs of valves
3.27. Expansion of openings of plugs
3.28. Valves
3.29. Klapannye of a spring
3.30. Saddles of valves
3.31. Oil pallet
3.32. A reception branch pipe with the oil filter
3.33. Oil pump
3.34. Repair of the oil pump
3.35. Pistons and rods
3.36. Flywheel. Back consolidation of a cranked shaft
3.37. Cranked shaft
3.38. Rods and radical bearings
3.39. Replacement of loose leaves
3.40. Piston fingers and rings
3.41. Block of cylinders
3.42. Installation of pistons
3.43. Disk balancing with a gear wreath
3.44. Repair of carving openings
3.45. Diagnostics of malfunctions
+
cooling System
+
Toplevnaya and exhaust systems
+
Electric chain
+
7. Ignition system
+
8. Electronic control unit and sensors
+
Transmission
+
10. Five-speed transmission and main RPO MM5 broadcast
+
11. Automatic Transmission
+
Steering
+
Running gear
+
14. Forward suspension bracket
+
15. Drive of forward wheels
+
16. Back suspension bracket
+
Brake system
+
Body
+
Heating, ventilation
+
Electric equipment
3.8. Maple belt
GENERAL INFORMATION
Maple belt
To remove or disconnect
PERFORMANCE ORDER
1.
Belt of a drive of the compressor of the conditioner of air.
2.
To weaken a bolt And generator fastenings (
Klinova's
fig.
a belt
).
3.
Maple belt of a drive of the generator.
To establish or attach
PERFORMANCE ORDER
1.
A belt B of a drive of the generator to measure a belt tension in the Page point.
Prevention
The tension of a maple belt should make 330–370 N (both for new, and for a maintained belt).
2.
To tighten a bolt And generator fastenings by the moment of 25 Hм.
3.
Belt of a drive of the compressor of the conditioner of air. To adjust a belt tension.
