Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
- 3. Engine (two top camshafts)
   3.2. General description
   3.3. Operation of hydraulic jacks of gaps
   3.4. Greasing system
   3.5. Maintenance and repair
   3.6. Compression check
   3.7. Dismantle and engine installation assembled
   3.8. Maple belt
   3.9. Engine support
   3.10. Inlet collector and laying
   3.11. Final collector and laying
   3.12. Cover of the klapanny mechanism and laying
   3.13. Pulley of a cranked shaft
   3.14. Forward cover of a gear belt
   3.15. Gear belt
   3.16. Natyazhitel of a gear belt
   3.17. Camshaft cogwheel
   3.18. Cogwheel of a cranked shaft
   3.19. Back cover of a gear belt
   3.20. Forward consolidation of a cranked shaft
   3.21. Camshaft. Hydrojacks of gaps of valves
   3.22. Head of the block of cylinders
   3.23. Repair of a head of the block of cylinders
   3.24. Klapannye of a spring. Consolidations of cores of valves
   3.25. Dismantle of valves
   3.26. Directing plugs of valves
   3.27. Expansion of openings of plugs
   3.28. Valves
   3.29. Klapannye of a spring
   3.30. Saddles of valves
   3.31. Oil pallet
   3.32. A reception branch pipe with the oil filter
   3.33. Oil pump
   3.34. Repair of the oil pump
   3.35. Pistons and rods
   3.36. Flywheel. Back consolidation of a cranked shaft
   3.37. Cranked shaft
   3.38. Rods and radical bearings
   3.39. Replacement of loose leaves
   3.40. Piston fingers and rings
   3.41. Block of cylinders
   3.42. Installation of pistons
   3.43. Disk balancing with a gear wreath
   3.44. Repair of carving openings
   3.45. Diagnostics of malfunctions
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

3.10. Inlet collector and laying

GENERAL INFORMATION

Branch pipe of an air purifier and electric sockets

Vacuum hoses

Butterfly valve case

Arm of an inlet collector

Dismantle of an inlet collector with laying

Sequence of an inhaling of bolts and nuts of fastening of an inlet collector

To remove or disconnect

PERFORMANCE ORDER

1. Bottom hose of a radiator and negative wire of the battery.

2. A collar and an air branch pipe of an air purifier from the butterfly valve case.

3. Ventilating hoses In and Page.

4. The electric socket D of the air valve of idling and the socket E of the sensor of provision of the butterfly valve, located on the butterfly valve case 97. Cable of 101 managements of a butterfly valve and arm of the 99th fastening of a cover of a cable.

5. Belt of the generator and bolt of a level of the generator.

6. A hose of G of a drain tank, a hose of a supply of cooling liquid from the corresponding branch pipes on the butterfly valve case.

7. A vacuum hose of the I regulator of pressure of fuel, a hose To the conditioner, a hose of J of the brake amplifier, a hose of the L sensor of absolute pressure and a "mass" wire of M of EBU.

8. Arm 76 inlet collectors, bolts 77, 78.

9. An inlet collector 92 with the laying 91, seven bolts 95 and two nuts 94. Sopryagaye my planes of a head of cylinders and inlet collector.

To establish or attach

PERFORMANCE ORDER

1. An inlet collector 92 with new laying 91 (see fig. Sequence of an inhaling of bolts and nuts of fastening of an inlet collector).

2. Nuts 94 and bolts 95. To tighten nuts and bolts of fastening of an inlet collector the moment of 25 Nanometers in the sequence shown on fig. Sequence of an inhaling of bolts and nuts of fastening of an inlet collector.

3. Arm 76 inlet collectors, top bolts 77, bottom bolt 78. To tighten the top bolts the 77th moment of 25 Nanometers, and the bottom bolt the 78th moment of 40 Nanometers.

4. A vacuum hose of the I regulator of pressure of fuel, a hose To the conditioner, a hose of J of the brake amplifier, a hose of the L sensor of absolute pressure and a "mass" wire of M of EBU.

5. A hose of G of a drain tank, a hose of N of a supply of cooling liquid to the butterfly valve case.

6. A generator level on an inlet collector.

7. A driving belt of the generator and to adjust a belt tension.

8. Arm of the 99th fastening of a cover of a cable and cable of 101 managements of a butterfly valve. The electric socket D of the air valve of idling and the socket E of the sensor of provision of the butterfly valve, located on the butterfly valve case 97.

9. Ventilating hoses With and In to branch pipes on a cover of the klapanny mechanism, the case of a butterfly valve and a collector of a vozdukhochistitel.

10. An air branch pipe of an air purifier to the butterfly valve case to establish a collar.

11. To fill system of cooling with cooling liquid. If necessary to remove air from system.

12. Negative wire of the storage battery.