Daewoo Nexia

since 1994 of release

Repair and car operation



Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
- Fuel and exhaust systems
   5.2. System of injection of fuel
   5.3. Modes of functioning of system
   - 5.4. Main knots of system
      5.4.1. Fuel tank, pump and pipelines
      5.4.2. Distributive fuel pipeline
      5.4.3. Fuel nozzles
      5.4.4. Regulator of pressure of fuel
      + 5.4.5. Butterfly valve case
      5.4.6. Relay of pressure of oil
      5.4.7. Relay of turning on of the fuel pump
      5.4.8. Check of giving of the fuel pump
      5.4.9. Fuel tank
      5.4.10. Accelerator pedal
      5.4.11. Fuel filter
      5.4.12. Fuel pump
      5.4.13. Dumping of pressure of fuel in system
      5.4.14. Distributive fuel pipeline
      5.4.15. Fuel nozzles
      5.4.16. Regulator of pressure of fuel
      5.4.17. Butterfly valve case
      5.4.18. Sensor of provision of a butterfly valve (DDZ)
      5.4.19. Valve of idling (KHH)
      5.4.20. Replacement of the case of a butterfly valve
      5.4.21. System of compulsory ventilation of a case (SPVK)
      5.4.22. Check of functioning of the valve of ventilation of a case (KVK)
      5.4.23. System of production of the fulfilled gases
      5.4.24. Catalytic converter
      5.4.25. Reception exhaust pipe and catalytic converter
      5.4.26. The forward exhaust silencer with an intermediate exhaust pipe
      5.4.27. The back exhaust silencer with an exhaust pipe
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


8128da4b



5.4.10. Accelerator pedal

GENERAL INFORMATION

At service of a pedal of an accelerator it is necessary to observe the following requirements.

The interfaced planes of an arm of a suspension bracket of a pedal and forward board of the Body should be free from an insulating material. The rug, a covering of a floor and the tunnel should be straightened and not have folds.

To pass a cable in a cut of draft of an accelerator and to establish a clamp, having checked correctness of its situation. Carefully запрессо вать a clamp in a draft opening not to overwind a cable or not to damage it in a different way. After assembly to check freedom of movement and absence of jammings of a drive of a butterfly valve and an accelerator pedal in a full range of movings. Wires, hoses and other details should not be closer than 13 mm to mobile details of a drive of a butterfly valve at any provision of a pedal of an accelerator.