Ventilating hatch
1. WASHER
2. SCREWS
3. SLIP
4. INTERMEDIATE PLATE
5. PAD
6. HOLDER
7. SCREWS
8. LOOP
9. LOOP COVER
10. HOLDER OF THE FRAME
11. HOLDER OF THE FRAME
12. RIVET
13. LOOP
14. INTERMEDIATE PLATE
15. INTERMEDIATE PLATE
16. LOOP LATCH
17. LOOP
18. RIVET |
19. HANDLE
20. SPRING
21. PLUG
22. AXIS
23. AXIS
24. CLIP
25. AXIS
26. PLATE OF THE HOLDER
27. HOLDER OF THE BUTTON
20. SPRING
29. HOLDER
30. FRINGING
31. HOLDER OF THE NUT
32. SEALING LAYING
33. FRAME
34. HOLDER OF THE FRAME
35. SEALANT
36. GLASS PANEL |
The ventilating hatch opens by pressing the lock handle forward and is fixed in open situation by pressing the handle up. One fixed position of the open hatch with the back edge raised on 40 mm is provided. The hatch can be dismantled from the car. For this purpose it is necessary to open the hatch at first. Then to press two pads of clamps and to raise slightly the hatch of, to disconnect forward sharnirny loops.
To establish the glass hatch into place, it is necessary to execute the following operations. To put the hatch in vertical situation by a forward edge on the sealant middle. To combine the loops fixed on glass, with the corresponding grooves in a roof aperture. When jamming loop in a cut of an aperture of a roof, it is necessary to repeat installation anew. To insert a ledge of a latch to a nest for hatch fixing. To turn the lock handle down for complete locking of the hatch.
Use of silicone greasing prolongs service life of consolidation and improves its tightness. It is necessary to grease a sealant once in six weeks.
Adjustment of provision of glass for ensuring reliable contact on a contour of a sealant is reached by means of addition or removal of laying of the locking device. |
