Daewoo Nexia

since 1994 of release

Repair and car operation



Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
- Body
   18.2. Identification and use of keys
   18.3. Pasted lateral moldings
   18.4. Diagnostics and repair of a leakage of the Body
   18.5. Anticorrosive processing
   + 18.6. Dismantle of consolidations of wind and back glasses
   + 18.7. Windscreen
   + 18.8. Back glass (Body sedan)
   18.9. Glass of a back door (Body hatch-back)
   18.10. Triangular lateral glass
   + 18.11. Elimination of a leakage of consolidations
   + 18.12. Rear-view mirror
   + 18.13. Electroheater of back glass
   + 18.14. Bumpers
   18.15. External ventilating lattice
   18.16. Switch of a forward door
   18.17. Cowl
   18.18. Cowl loops
   18.19. Cowl emphasis
   18.20. Locking device of a cowl
   18.21. Safety latch of a cowl
   18.22. Cable of a latch of a cowl
   18.23. Front grille
   18.24. Forward wing
   + 18.25. Panels of an upholstery of doors
   + 18.26. Equipment of doors (lobbies and back doors)
   + 18.27. Door locks
   + 18.28. Glasses of doors
   18.29. External rear-view mirrors
   18.30. Dismantle and installation of lobbies and back doors
   + 18.31. Back panels of an upholstery (Body hatch-back)
   + 18.32. Upholstery panels (Body sedan)
   18.33. External panel
   18.34. Ventilating valve (Body hatch-back)
   18.35. Hatch of a mouth of a fuel tank
   + 18.36. Opening window leaves (A body a hatch-back)
   + 18.37. Back shelf (Body sedan)
   18.38. Cover of a luggage compartment (Body hatch-back)
   18.39. Overlay of a back wall of a luggage carrier (Body sedan)
   + 18.40. Trunk lid (Body sedan)
   18.41. The back combined lamp
   + 18.42. Back door (Body hatch-back)
   18.43. Roof
   18.44. Ceiling panel
   18.45. Antisolar peaks
   18.46. Plafond of internal lighting
   + 18.47. Panels and salon equipment
   18.48. External longitudinal overlays of a roof
   + 18.49. Ventilating hatch
   + 18.50. Forward seats
   + 18.51. Back seat
+ Heating, ventilation
+ Electric equipment


8128da4b



18.4. Diagnostics and repair of a leakage of the Body

GENERAL INFORMATION

Successful elimination of a leakage of the Body depends on the correct carrying out diagnostics for the purpose of localization of malfunctions of the Body and is reached by adjustment of mutual provision of elements of the Body and its equipment, and also application of special repair hermetics. The first stage is definition of conditions at which about the Body of the car water gets. For example, water can proceed in the Body when parking on an inclined platform or get only to office for placement of a spare wheel etc. After the zone of a leakage is approximately defined, the exact arrangement of a place of hit of water can be quickly established by means of a water or air stream from a hose. If it was not possible to find not tight place, it is necessary to execute complete test of the Body for tightness by means of the special equipment. At diagnostics and repair of the Body it can be demanded to dismantle some panels of an upholstery and a part of the equipment of the Body.
Prevention

It is necessary to define precisely a place of hit of water in the Body before undertaking any measures for malfunction elimination. Otherwise only the temporary effect will be gained. Further diagnostics and repair can be considerably complicated.

Check of a suspicious place should be continued until all ways of hit of water to the Body will be found.


Check of tightness of the Body by means of a hose with water

At carrying out this check in salon of the car there should be an assistant for control of water hit in the Body.

It is necessary to use a hose without a directing nozzle.

Check should be begun with the lower part of a suspicious place and gradually to be displaced up.