Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. Forward suspension bracket
   14.2. General description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Check of a condition of bearing support and spherical hinges
   14.5. Stabilizer
   14.6. A rack assembled with a bearing support
   14.7. Bottom lever
   14.8. Spherical hinge
   14.9. Nave and wheel bearing
   14.10. Top support
   14.11. Springs
   14.12. Shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

14.8. Spherical hinge

GENERAL INFORMATION

Spring clamp

AND. BACK HANDLE
CENTURY. FORWARD LOOPS
PAGE. CLAMPS

1. SPRING CLAMP

To remove or disconnect

Removal of rivets of the spherical hinge

PERFORMANCE ORDER

1. To release bolts of fastening of forward wheels.

2. To lift the car.

3. To bring basic racks under the car or under suspension bracket support.

4. To lower it is a little car so that he leaned on racks, but not on the bottom levers.

5. Forward wheels.

Prevention

To track that the semi-axis did not leave the internal mobile hinge. It will lead to hinge dismantling. Probably also hinge damage. During work in a zone of an arrangement of hinges of semi-axes it is necessary to use the protective covers which are put on rubber antisplash consolidations of hinges. Otherwise damage of details or consolidations of hinges and an exit of hinges out of operation is possible.

6. Spring clamp of 1 nut of the spherical hinge 6.

6а. To raise a back handle of a clamp and to take out it for forward loops, see fig. Spring clamp.

7. The spherical hinge 6 from a rack 33. To use a stripper for spherical KM-507B hinges.

8. Bottom lever.

9. To drill heads of three rivets of fastening of the spherical hinge and to beat out rivets from openings to small beards. For drill vaniye to use 12-mm a drill.

To establish or attach

Boltovoye fastening of the spherical hinge to the lever

PERFORMANCE ORDER

1. The spherical hinge 6 on the bottom lever 13.

2. Three bolts with nuts in openings of rivets in the bottom lever (instead of rivets). To tighten nuts the demanded moment. Nuts should be established from below the lever.

3. Bottom lever.