Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. Forward suspension bracket
   14.2. General description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Check of a condition of bearing support and spherical hinges
   14.5. Stabilizer
   14.6. A rack assembled with a bearing support
   14.7. Bottom lever
   14.8. Spherical hinge
   14.9. Nave and wheel bearing
   14.10. Top support
   14.11. Springs
   14.12. Shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

8128da4b Furniture Assembly in NY

14.12. Shock-absorber


The description of operations on dismantle of a telescopic rack is provided in subsection 14.6.

To remove or disconnect

1. To compress a suspension bracket spring.
2. Protective cover of the top support.
3. Nut 35 and washer 34. (To use the J36710 adaptation).
4. To dismiss a spring.
5. Top support of the 39th rack, tarelchaty washer 40, plastic support 41, protective casing of a rack 42, top laying of a spring 43, spring 44, buffer of compression 45, bottom laying of a spring 46.
6. A screw cover of 31 racks by means of key KM-331. The cover is tightened by the considerable moment of 200 Nanometers.
7. Shock-absorber 32.

To clear

1. Female thread of a rack.
2. To use a new carving cover 31 of a set of spare parts of the shock-absorber.

To establish or attach

The new cover 31 is covered with paraffin which it is not necessary to delete. Paraffin at the same time is lubricant and protects from corrosion.

1. Cover 31. To use a new cover. To tighten a screw cover of 31 racks the moment of 200 Nanometers.
2. To establish a rack in adaptations for spring compression.

Before installation of the top support of a rack it is necessary to be convinced that the ball-bearing of a support is greased properly.

3. Following details: 46, 45, 44, 43, 42, 41, 40, 39.
4. To compress a spring.
5. Washer 34.
6. Nut 35. To tighten a nut of the 35th fastening of a rod the moment of 55 Nanometers.
7. Operations on installation on the car of a rack of a suspension bracket are described in subsection 14.6.