Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. Forward suspension bracket
   14.2. General description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Check of a condition of bearing support and spherical hinges
   14.5. Stabilizer
   14.6. A rack assembled with a bearing support
   14.7. Bottom lever
   14.8. Spherical hinge
   14.9. Nave and wheel bearing
   14.10. Top support
   14.11. Springs
   14.12. Shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

14.13. Plugs of hinges of the bottom lever

To remove or disconnect

Operations on dismantle of the bottom lever are described in subsection 14.7.

To disassemble

Dismantle of the back plug of the lever

AND. PRESS
CENTURY. PUSHER
PAGE. PRESS EMPHASIS

13. BOTTOM LEVER

Dismantle of the forward plug of the lever

AND. PRESS
CENTURY. PUSHER
PAGE. PRESS EMPHASIS

13. THE BOTTOM LEVER (ВЫПРЕССОВЫВАТЬ IN THE DIRECTION IN FRONT BACK)

PERFORMANCE ORDER

1. Plug of a back support of the lever. Выпрессовать the plug by means of a pusher.

2. The plug of a forward support of the lever by means of the KM-508A adaptation and a punch выпрессовать the plug in the direction in front back.

To collect

Installation of the back plug of the lever

AND. PRESS
CENTURY. TO MOISTEN WITH SOAP SOLUTION
PAGE. PRESS EMPHASIS

13. BOTTOM LEVER
14. THE BACK PLUG OF THE LEVER THE FLAT PARTY OF THE PLUG SHOULD SETTLE DOWN FROM THE SAME PARTY, AS THE FINGER OF THE SPHERICAL HINGE

PERFORMANCE ORDER

1. Plug of a back support of the lever.

1а. To moisten a back thorn of the lever with soap solution and напрессовать on it the plug. The flat party of the plug 14 should settle down from above, from the same party, as a finger of the spherical hinge.

2. Plug of a forward support of the lever.

2а. To moisten with soap solution an external surface of the plug.

2б. To press the new plug in a lever opening. Installation of the plug to make from the forward party of the lever.

To establish or attach

Operations on installation of the bottom lever on the car are described in subsection 14.7.