Daewoo Nexia

since 1994 of release

Repair and car operation



Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
- Transmission
   9.2. General description
   9.3. Diagnostics of malfunctions
   9.4. Cable of a drive of coupling
   9.5. Coupling pedal
   9.6. Conducted and press disks, a coupling drive
   9.7. Air removal from a hydraulic drive of coupling
   9.8. Main cylinder
   9.9. Working cylinder of coupling
   9.10. Main malfunctions of coupling, their reason and ways of elimination
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


8128da4b Докукин а, в, радиально-поршневые гидромоторы многократного действия.
лемех плуга.
Намотка одометра здесь еще больше.



9.9. Working cylinder of coupling

GENERAL INFORMATION

Working cylinder of coupling

9. WORKING CYLINDER
57. ROD
59. THE VALVE FOR AIR REMOVAL
64. CAP
65. CUFF
66. JET
67. SPRING
63. RETURNABLE SPRING
65. CUFF
70. PISTON
71. LOCK RING
72. COVER

To remove or disconnect

PERFORMANCE ORDER
1. To disconnect a hydraulic hose from the working cylinder, having unscrewed by means of a wrench a bolt 11.
2. To turn out fixing bolts 7 and to take out the working cylinder from an arm 8.

To disassemble

Dismantle of the working cylinder of coupling

7. BOLT
8. ARM OF THE WORKING CYLINDER
9. WORKING CYLINDER
10. COPPER WASHER
11. BOLT
12. THE HOSE WITH TIPS
59. THE VALVE FOR AIR REMOVAL

Piston dismantle from the working cylinder by means of the compressed air


PERFORMANCE ORDER
1. To remove a cover 72 from a rod 57.
2. To drown by means of a screw-driver the piston in the cylinder and to remove a spring lock ring (to use nippers strippers).
3. To take out the piston assembled. If the piston is not taken out, to bring to an entrance opening of the cylinder the compressed air and to squeeze out the piston outside.

To remove or disconnect

PERFORMANCE ORDER
1. To grease with fresh brake liquid the piston 70 and a sealing cuff 69.
2. To establish a spring on the piston and to insert it into the working cylinder.
3. To drown by means of a screw-driver the piston in the cylinder and to insert into a cylinder flute a spring lock ring (to use nippers strippers).
4. To insert into the cylinder a rod 57 and to put on a cover 72.

To establish or attach

PERFORMANCE ORDER
1. To insert the working cylinder 9 into an arm 8 and to fix it bolts.
2. To insert into an entrance opening of the working cylinder a spring and a jet, to attach to the cylinder through two copper washers a tip of a hydraulic hose.
Prevention

To grease with konsistentny greasing interfaced surfaces of a rod of the working cylinder and the lever of the roller of coupling.


3. After assembly to remove air from a coupling hydraulic actuator, to adjust a course of a pedal and to finish level of working liquid in a tank to norm.