Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
- Electric chain
   6.2. General description
   6.3. Rules of care of the accumulator
   6.4. Accumulator check
   6.5. Battery charging
   6.6. Storage battery
   6.7. System of start-up of the engine
   6.8. Diagnostics of malfunctions
   6.9. Algorithm of diagnostics of malfunctions
   6.10. Traction relay
   6.11. Coupling of a free wheeling (MCX)
   6.12. Repair of knots of a starter of 5MT and 10МТ
   6.13. Generator
   6.14. Diagnostics of malfunctions of the CS-121 generator
   6.15. Generator dismantle
   6.16. CS-130 generator repair
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

6.4. Accumulator check

GENERAL INFORMATION

Indicator of degree of a zaryazhennost and level of electrolit of the unattended DELCO accumulator

Interpretation of the symbols put on a label of the accumulator

1–At service of the accumulator it is necessary to observe rules according to the safety measures, stated in the operation manual.
2–In the accumulator there is a corroding acid and it is necessary to be careful, that acid did not spill from the accumulator.
3–Do not use open fire about the accumulator.
4–At work with the accumulator use goggles.
5–Keep the accumulator in a place not available to children.
6–At utilization the accumulator hand over only in the points intended for this purpose.
7–Do not throw out the accumulator together with household garbage.
8–The gases allocated at a battery charging are explosive.

In the accumulator it is necessary to make check of density of electrolit each 3 months to define loading ability of the accumulator.

Check is made by a plotnomer. At determination of density of electrolit it is necessary to consider accumulator temperature. At temperature of electrolit is lower 15 ° With on everyone 10 ° less than this temperature from the measured density subtract value 0,007. For everyone 10 ° over 15 ° add 0,007.

The electrolit density in the accumulator should be in the following limits:

	Temperature
	Above 25 ° With	Below 25 ° With
Full charging	1,210-1,230	1,270-1,290
Charging for 70 %	1,170-1,190	1,230-1,250
The discharged	1,050-1,070	1,110-1,130

Density of electrolit measure in everyone bank. The difference in density 0,04 or more between two any banks indicates loss of electrolit or a sulfatatsiya of plates.

If the electrolit density between two any banks differs more than on 0,04 accumulator is subject to replacement. If the density of electrolit is lower demanded, but identical in all banks, the accumulator is necessary for charging.

In case of use of the unattended accumulator the condition of the accumulator can be checked only the voltmeter. In accumulators with the built-in indicator of degree of a zaryazhennost the condition of the accumulator is determined by color of the indicator. Green color of the indicator corresponds to a full battery charging. Black color of the indicator indicates need of a battery charging. Light or bright yellow color of the indicator testifies to low level of electrolit in the accumulator (see fig. Indicator of degree of a zaryazhennost and level of electrolit of the unattended DELCO accumulator).

On the accumulator there is a sticker with warning symbols (see fig. Interpretation of the symbols put on a label of the accumulator).