Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
- 16. Back suspension bracket
   16.2. General description
   16.3. Maintenance and repair
   16.4. Check of size of forces of a friction in a suspension bracket
   16.5. Bearings of wheels
   16.6. Shock-absorber
   16.7. Stabilizer
   16.8. Springs
   16.9. Plugs of hinges of a back suspension bracket
   16.10. Back suspension bracket assembled
   16.11. Nave
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

виза в индию для россиян

16.11. Nave

To remove or disconnect

Consolidation dismantle

AND. SCREW-DRIVER

10. CONSOLIDATION
12. NAVE

PERFORMANCE ORDER

1. To lift the car and to fix properly.

2. Wheels.

3. Brake drums (the lock screw, if necessary to weaken a cable of the parking brake to take away inside by means of a screw-driver razzhimny the lever of the parking brake).

Prevention

It is forbidden to knock a hammer on a brake drum as it can put out of action bearings.

4. Protective cap 17, шплинт 15 and nut 16.

5. A nave 12 with a lock washer 14.

6. Consolidation 10 from a nave 12 by means of a screw-driver.

7. A separator with rollers and an internal ring of the conic bearing 11 from a nave 12.

8. An external ring of the bearing 11 from a nave 12 by means of a stripper or suitable a small beard.

9. An external ring of the bearing 13 from a nave 12 by means of a stripper or suitable a small beard.

10. To clear a pin and to check its technical condition, existence of defects.

To establish or attach

Installation of consolidation of the internal bearing

12. NAVE

PERFORMANCE ORDER

1. To press against the stop an external ring of the bearing 13 in a nave 12 by means of the assembly KM-266A adaptation.

2. To press against the stop an external ring of the bearing 11 in a nave 12 by means of the assembly KM-266A adaptation.

3. Internal bearing 11.

4. To grease or fill with konsistentny greasing for bearings all cavities of bearings 11 and 13, an edge of consolidation 10 and a nave 12.

5. To press consolidation in a nave 12.

6. A nave 12 and a lock washer 14 on a pin.

7. Nut.

8. Brake drum.

8а. To tighten the lock screw of a brake drum.

8б. To establish back wheels and to tighten bolts the moment of 90 Nanometers.

9. To adjust bearings of wheels.

10. To adjust the parking brake.

11. To lower the car.