Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
- Running gear
13.2. Replacement of wheels
13.3. Wheel bolts
13.4. Running in of tires
13.5. Storage of tires
13.6. Balancing of wheels
13.7. Antisliding chains
13.8. Pressure check in tires
13.9. Check of a profile of tires
13.10. Gate check
13.11. Corners of installation of wheels of the car
13.12. Preliminary check of a technical condition
13.13. Adjustment of a convergence of forward wheels
13.14. Check of a convergence of back wheels
13.15. Check of a corner of disorder of back wheels
13.16. Designations of rims and tires
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment
|
Adjustment of a convergence of forward wheels
|
|
AND. TO ADJUST THE CONVERGENCE OF WHEELS SCREW ROTATION
Century. To weaken the INHALING of BOLTS of KLEMMOVS of CONNECTIONS. AFTER ADJUSTMENT to TIGHTEN the MOMENT of 20 Nanometers
1. TIP OF STEERING DRAUGHT
2. SPRING RACK OF THE SUSPENSION BRACKET |
The convergence of forward wheels is regulated by change of length of steering drafts. To release bolts In klemmovy clips on the left and right steering draft. Then rotation of adjusting screws A to establish demanded value of a convergence of forward wheels. Thus lengths of steering drafts should be identical. To tighten bolts of klemmovy connections of steering drafts the moment of 20 Nanometers. |
|
