Daewoo Nexia

since 1994 of release

Repair and car operation

Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
- Cooling system
   4.2. General description
   4.3. Care of cooling system
   4.4. Thermostat check
   4.5. Check of tightness of system of cooling
   4.6. Plums and filling of system with cooling liquid
   4.7. Thermostat
   4.8. Water pump
   4.9. Electric fan
   4.10. Broad tank
   4.11. Sensor of a signaling device of an overheat of the engine
   4.12. Radiator
   4.13. Diagnostics of malfunctions of system of cooling
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment

4.6. Plums and filling of system with cooling liquid

PERFORMANCE ORDER

1. To put under the car the pallet for collecting OZh.

2. To uncover a broad tank.

3. To weaken a collar of the bottom hose of a radiator and to disconnect a hose from a branch pipe of a radiator or to open the drain crane.

4. To collect OZh in the pallet.

5. To remove, wash out and establish into place a broad tank.

6. After full OZh plum to attach a hose to a radiator and to fix a collar, to close the drain crane if it was open.

7. To fill in through a mouth of a broad tank pure water. To fill a tank slowly that the top hose remained constantly above a water level. It is necessary for an air outlet from cooling system.

8. To start the Engine and to warm up it to the temperature corresponding to opening of the valve of the thermostat. Thus water will start to circulate through a radiator and hoses of a radiator will heat up.

9. To switch off the Engine. To repeat operations with the 1st on 8th several times while merged water becomes pure and without color of a rust.

10. To fill in about system through a mouth of a broad tank fresh OZh. OZh should contain at least 50 % этиленг ликоля. Concentration этиленгликоля more than 70 % is not allowed. To fill a broad tank to a label the MOVE.