Daewoo Nexia

since 1994 of release

Repair and car operation



Deu Neksiya
+ Maintenance instruction
- Maintenance
   1.2. General instructions on repair
   1.2. Identification number of the car
   1.3. Car lifting
   1.4. Car maintenance
   + 1.5. Control surveys and the servicing, carried out by the owner
   1.6. Moments of an inhaling of carving connections
   1.7. Car characteristics with system of multipoint injection of fuel
   1.8. Characteristics of cars (2 top camshafts of the engine)
   1.9. Sizes and mass of cars
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. Forward suspension bracket
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


8128da4b



1.2. General instructions on repair

GENERAL INFORMATION

When using a floor jack it is necessary to observe the following rules. Put the car on a horizontal platform. Block from possible movings a forward or back wheel. Establish a jack under a basic nest of the Body and lift the car. Substitute under the car safety rigid support. Only after that it is possible to start carrying out servicing or repair.

Before work DISCONNECT the "MASS" WIRE of the storage battery in order to avoid damages of the car and traumas because of short circuit.

Use safety covers for protection of the Body, seats and rugs on a floor from damages and pollution. Do not allow hit of brake liquid and cooling liquid on a car Body as they can damage a paint and varnish covering.

Use only the serviceable tool recommended in this management.

The reuse шплинтов, laying, sealing rings of round section, manzhetny consolidations, lock washers and самоконтрящихся nuts is not allowed. At assembly of units it is necessary to replace them with new details. Otherwise normal operation of units cannot be guaranteed.

For simplification and acceleration of assembly of units accurately store the disassembled details in separate groups.

Do not confuse various fixing bolts and nuts as they differ on durability and design features depending on an installation site.

Clear details of pollution before their survey or installation.

Details of oil systems also are subject to cleaning and a purge the compressed air for removal of all pollution.

Before installation of details grease surfaces of sliding and rotation by liquid oil or konsistentny greasing.

If necessary for elimination of a leak of oil or operational liquids use hermetic together with sealing laying.

Carefully observe requirements to size of the moment of a tightening of bolts and nuts.

After completion of servicing or repair carry out final check to be convinced of the correct performance of all operations and malfunction elimination.